Nextel comm Modem IR1200 User Manual download pdf (Page 104)

iR1200 Modem

94 nextel.com

Message Explanation

• An invalid parameter was entered.

The command line is ready for another

command. Make sure that the command

(and parameter) that you entered are valid.

BUSY

The number you called is busy. You should

try the call again later. The modem is ready

to accept another command.

MODEM

INITIALIZATION

FAILED

Your communication software assumes that

Auto Baud is supported by the modem.

Make sure that:

• That the baud rate = 19200 bps.

• If Auto Baud is turned on in the

software, it must be turned on in the

programming menu of your modem.

NO CARRIER

Your connection was terminated, or an

attempt to establish the connection failed.

Try your call again and contact your iDEN

carrier.

Diagnostic Commands

If a data connection could not be established, you might be able to determine

the cause through the AT command interface.

The following steps describe how to obtain modem or system information that

will help you with configuration or communication problems.

1 Close all data applications. These applications may start a

retry command that will interfere with your troubleshooting

efforts.

Unplug and reconnect the data cable. This will terminate

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 121 122

No comments

Nextel comm Modem IR1200 User Manual Page 104